SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.B Y : S H E R W O O D I N D U S T R I E S
Figure 9: Install the Rock Set Burner to the Firebox.10Maintenance And ServiceREPLACING THE GLASS:IMPORTANT: Do not operate with the glass front remov
To install the burner:1. Insert the mixing tube into the mixing tube box (refer to Figure 8 or 9).2. When the burner is resting in the rebox en
12Maintenance And ServiceFUEL CONVERSION:TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLYPlease read and understand these instructions before instal
Figure 18: Removing valve cap.Maintenance And Servicescrew must be not visible.Figure 20: Flip valve screw.Red o-ringis not visibleRed o-ringis visibl
14Initial InstallationQUALIFIED INSTALLERS ONLYWARNING: Operation of this heater when not connected to a properly installed and maintained venting sys
Initial InstallationQUALIFIED INSTALLERS ONLYPLANNING YOUR INSTALLATION:The Cara DR is only for horizontal rear vent installations. The maximum horiz
161 In accordance with the current CSA B149, Natural Gas and Propane Installation Code.2 In accordance with the current ANSI Z223.1 NFPA 54, National
Initial InstallationQUALIFIED INSTALLERS ONLYINSTALLATION OF APPLIANCE:SealantFemaleLockingLugsMaleLockingLugsFigure 26: Twist-Lock Connection.- PO512
Initial InstallationQUALIFIED INSTALLERS ONLYWood screws (x4)Cut vinyl sidingaway to fit standoffBolt (x4)requiredNut (x4)requiredWoodscrew (x4)Figure
19(b) For buildings with vinyl siding, a vinyl siding standoff, should be installed between the vent cap and the exterior wall (see
2FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” HEATER, PLEASE CAREFULLY READ THE FOLLOWING INFORMATION:• All ENVIRO gas-red appliances must b
Initial InstallationQUALIFIED INSTALLERS ONLYGAS LINE CONNECTION AND TESTING:WARNING: Only persons licensed to work with gas piping may make the neces
21Initial InstallationQUALIFIED INSTALLERS ONLYELECTRICAL REQUIREMENTS FOR GAS VALVE AND OPTIONAL BLOWER:The ENVIRO CARA will operate without electric
Figure 36: Optional Blower (Fan) Installation.1. Remove the pre-assembled blower from the packaging. Inspect the blower for damage. If damage is noti
23Figure 39: Log Placement of Right Log.The placement of the logs is not arbitrary. If they are positioned incorrectly, the ames can be “pinched” and
Secondary InstallationFigure 42: Log Placement Complete.Figure 40: Log Placement of Left Log.Left LogCenter LogFigure 41: Log Placement of Center Log.
25INSTALLATION OF ROCK SET:If the rocks are positioned incorrectly, the ames can be “pinched” and will not burn correctly. If the rocks are broken du
26Secondary InstallationFigure 45: Rock Placement of Four Large Rocks.Figure 46: Rock Placement of Two Medium Rocks.Figure 47: Rock Placement of Seven
Secondary InstallationImportant note: When the unit is turned on for the rst time, it should be turned onto high without the fan on for the rst four
Trouble ShootingProblem Possible Cause SolutionThe main burner does not ignite when called for.The gas valve may not be on. • Check that the gas c
29Parts ListReference NumberPart Description Part Number1 120°F (49°C) Ceramic Fan Temperature Sensor EC-001Thermopile EC-0122 S.I.T. Piezo Igniter EC
Table of Contents3Safety Precautions...2Table of Con
Parts ListReference NumberPart Description Part Number8 Cara Glass with Gasket - 14” x 16” (368mm x 425mm) 50-16139 Cara Door Latch Assembly 50-1594
31Parts Diagram
WarrantySherwood Industries Ltd. is the manufacturer of the VistaFlame line of heating products. At Sherwood Industries, our commitment to the highest
334. The stove must be operated and maintained at all times in accordance with the instructions in the Owner’s Manual. If the unit shows signs of neg
19. The paint on the Metal Brick Liner may peel. This is due to the extreme conditions applied to the paint during normal usage. It is not a aw and i
35Installation Data SheetThe following information must be recorded by the installer for warranty purposes and future reference.NAME OF OWNER:________
4DIRECT VENT ONLY: This type is identied by the sux DV. This appliance draws all of its air for combustion from outside the dwelling, through a spec
5SpecificationsWARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxid
6Operating InstructionsFor Your Safety, Read Safety Precautions And Lighting Instructions Before Operating.WARNING: IF YOU DO NOT FOLLOW THESE INSTRUC
7AIR SHUTTER:Air Shutter Adjustment NutFigure 5: Air Shutter Adjustment.The air shutter is controlled by sliding the air shutter adjustment s
Operating InstructionsFor Your Safety, Read Safety Precautions And Lighting Instructions Before Operating8The ideal ame will be blue at the base and
9Maintenance And ServiceROUTINE MAINTENANCE:At least once a year, run through the following procedures to ensure the system is clean and working prope
Comments to this Manuals