Enviro Focus Owner's Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
17
Secondary Installation
INSTALLING FAN CONTROLLER
This is for installing the fan controller when using
the cast iron faceplate and bay door assembly.
Install the fan controller in the control panel
already provided on this unit (see right).
Cut one wire tie so that the wires can be dressed
correctly through the body of the unit. Place the
Orange and White wires behind the front edge of
the replace bottom, and connect the two wires
at the fan controller. Use wire ties provide to
bundle and secure wire.
LOG SET AND EMBER INSTALLATION:
Orange and white wire
Fan controller location
Back Placement/Support Pins
The placement of the logs is not arbitrary. If they are
positioned incorrectly, the ames can be “pinched”
and will not burn correctly. The burner comes with
placement pins and rest areas, which make alignment
easier. Using the pictures provided, carefully set the
logs in place.
NOTE: The logs are fragile and should be handled
with care.
Place the rear log on the two back placement
pins.
Install the left front log on the left placement
pin with the narrow end of the log resting on
the rectangular rest area. Install the right front
log on the right placement pin with the narrow
end of the log resting on the rectangular rest
area. These two logs should meet tip to tip on
the rest area.
One end of the big log twig will rest on the pin
on the right log and the other will lay within
the left rest area. The small log twig should be
placed so it sit completely within the right rest
area.
Once the logs are in place the embers can be
placed lightly between the logs. Bags of ceramic
ber embers and rock wool are provided. The
ceramic ber comes in chunks that are about
2”-4” (5-10cm) long. Break these roughly in
half and place them irregularly around the
burner. When there is a sparse but even layer
of embers, spread the rock wool in the same
manner. DO NOT pack this ember material
as this could create an unsafe condition. The
pieces should be lightly place so they don’t
completely block any of the tiny ports. DO NOT
allow any of the embers to rest against the
pilot assembly.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Comments to this Manuals

No comments