PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCESHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED P
1. Install the wall thermostat in a location that is not to close too the unit but will effectively heat the desired area.2. Install a 12 or 24 Volt T
11InstallationSLIDER/DAMPER SETTING:This is used to regulate the airflow through the pellet stove.THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLAT
TroubleshootingDO NOT:● Service the stove with wet hands. The stove is an electrical appliance, which may pose a shock hazard if handled improperly.
13TroubleshootingüCheck the exhaust blower voltage across the blower wires (>=114V on #5 setting and >= 82V on #1 setting). – Replace the Circui
TroubleshootingAuger light flashes but auger motor does not turn at all.üIf the auger gear box does not turn but the motor’s armature does try to spin
15ConnectThermostatHereRedRedRedRedBrownBrownBrownBrownThermostatSelector PinsWhiteWhiteWhite115VWhite220VBlueWhiteWhiteOrangeOrangeOrangeOrangeYellow
Parts ListReference NumberDescriptionPart Number1 120 °F (49 °C) Ceramic Fan Temperature Sensor EC-001Domestic Power Cord - 115V EC-0422 Auger Motor -
17Parts ListReference NumberDescriptionPart Number15 Exhaust Starter Tube 3” Quick Connect 50-139116 Mother Board - 120V 50-139217 Daughter Board - 12
Parts Diagram - Components3Empress - Fireplace Insert ComponentsOctober 2006198112121421171651018
19Parts Diagram - Parts6Empress - Fireplace Insert PartsOctober 20063032132241825232824262773129191520
Table of Contents2Introduction...3Rating Lab
20WarrantySherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to
WarrantyExclusions and Limitations:1. This Warranty does not cover tarnish, discoloration or wear on the plating or paint. 2. This Warranty exclude
22Warranty17. Damage to plated surfaces caused by fingerprints, scratches, melted items, or other external scores and residues left on the plated surf
23NAME OF OWNER:_________________________________________ADDRESS:_____________________________________________________________________________________
3Introduction* This manual is designed for the technician in conjunction with the owner’s manual. *RATING LABEL LOCATION:The rating label is located o
4IntroductionELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord
5InstallationREMOVING PELLET STOVE FROM PALLET:Figure 1: Removing Stove From the Pallet. Use a flathead screwdriver or 5/16” socket to remove the four
Installation612"(30.5cm)Mantle36"(91cm)3"(7.6cm)24"(61cm)FloorProtection;Min6"(15cm)infrontofdoorFigure 4: Empress FPI Cleara
InstallationMASONRY FIREPLACE INSTALLATION:If installing the Empress with a skirt the skirt must be installed before the installation.A n
8InstallationPOSITIVE FLUE CONNECTION WITHOUT A FULL RELINE (USA ONLY):This unit does not require a full reline (in USA only) when installing into a m
INSTALLATION OF CAST SKIRT OPTION:Figure 9: Assembling Cast Skirt. InstallationADJUSTING HOPPER HEIGHT: The back height of this unit can be set to one
Comments to this Manuals