50-1578TECHNICAL MANUALPELLET STOVEWINDSORSHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.PLEA
10101/2”(265 mm)81/2”(216 mm)127/8”(326 mm)83/8”(214 mm)43/8”(112 mm)EXHAUSTBase of unit to center of flue 270 mm (10 ”)Side of unit to center of f
11Figure 8: Corner Installation. 100mm(4")100mm(4")Fresh Air IntakeWall thimblemanufacturedby pellet ventmanufacturer.InstallationCORNER THR
Exhaust80mm (3") or 100mm (4")Vent PipeWall Thimble45oElbow with Screenor Termination CapHigh Temperature RTVSilicone RequiredFresh Air Inta
13InstallationVERTICAL RISE WITH HORIZONTAL TERMINATION INSTALLATION (RECOMMENDED):A 45° elbow with a rodent screen may be used in place of the te
2Table of ContentsSafety Warnings & Recommendations...3Installation...
3Safety Warnings & Recommendations* This manual is designed for the technician in conjunction with the owner’s manual. *Please read this entire Ow
4Safety Warnings & RecommendationsCLEANING: There will be some build up of fly ash and small amounts of creosote in the exhaust. This will vary du
5Safety Warnings & RecommendationsFRESH AIR: Outside Fresh Air connection is optional. Fresh Air must be connected to all units installed in “Air
InstallationRATING LABEL LOCATION:The rating label is located on the back of the hopper.DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:1. Check clear
7Figure 2: Windsor Dimensions. 271/8"(689mm)253/4"(653mm)257/8"(659mm)153/8"(390mm)141/4"(360mm)241/8"(614mm)Installatio
This unit may be installed in an alcove. Maintain the clearances to combustibles shown in Figure 4.Minimum Alcove width 1220mm (48 inches)Minimum Al
9hot enough to cause burns if touched by children. Non-combustible shielding or guards may be required.3. Termination must exhaust above the inlet el
Comments to this Manuals