Enviro 828 MH Specifications download pdf (Page 10)

OPERATING INSTRUCTIONS

Control Board Functions

AUTO/T-STAT/Manual Switch: This switch selects the pellet stove operating mode.

Slide the switch to Manual (the far right position) to be able to manually select the heat

settings and controls.

If you have a remote thermostat attached and wish to have the pellet stove controlled by

the thermostat slide the switch to T-STAT (the middle position) to operate the pellet

stove in variable heat mode. The thermostat will control the heat output of the pellet

stove alternating between the lowest heat level and the highest heat level pre-selected by

the user.

The AUTO setting (far left position) is similar to the T-STAT setting except that the

stove will alternate between shutdown (stove turned completely off) and restart to the

user selected heat level, when commanded by the thermostat. When using a thermostat

the T-STAT position is recommended. This setting provides a more even heat output, for

better comfort, and will extend the life of the ignition system components. In addition

the constant flame, in the stove, will serve as a warning for people and pets to keep away

from the stove while in operation.

After switching between modes the stove should be turned Off and back On to reset the

control to operate in that mode.

On/Off Button: This button is used to turn the unit on and off. If the stove is cold prior

to start-up press and release the On/Off button. The green light above the On/Off switch

will flash to indicate start up cycle has started. Fuel pellets will start to feed into the burn

pot. The electric ignition system will be automatically activated, flames in the burn pot

will normally appear between 3 - 7 minutes. Once the flame has been established, the

start up cycle will end, this takes between 10 -15 minutes. At this point the user will be

able to make heat level adjustments.

If the stove is warm at restart the On/Off button must be pressed down and held for 2

seconds, or more, until the minimum heat level setting light is lit.

Heat Level: When pressed this increases the heat level setting one level. Pressing the

button will cycle the heat setting from minimum to maximum and back again. The

convection fan speed will also increase with the heat level setting. When the light is

flashing during the start up cycle the heat level button will not respond to the

adjustments. When the light is solid, indicating the start up cycle is finished, it will then

respond (only in manual mode).

Fan: Use this button to override the automatic fan speed control to turn the convection

fan on high. The smart control on this pellet stove will vary the fan speed in accordance

with the heat level setting. It is recommended to let the controller automatically adjust

the speed of the fan for optimum efficiency and minimal fan noise.

Auger: Pressing and holding this button will turn on the auger to speed feeding of pellets

into the burn pot, when first using the pellet stove or when you completely empty the

hopper of pellets and restarting after reloading the hopper. You can load the auger faster

by pressing and holding this button (until you see pellets dropping into the burn pot).

This button will turn off after 1 minute and must be released and pressed again if you

want to continue to manually operate the auger.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

Comments to this Manuals

No comments

Enviro 828 MH Specifications Page 10

Comments to this Manuals

Related products and manuals for Pellet stove Enviro 828 MH