Enviro 828 MH Specifications download pdf (Page 12)

THERMOSTAT INSTALLATION

An optional thermostat is available for use with this unit. A thermostat can help you

maintain a constant room temperature. A milli-volt thermostat is required.

NOTE: Your thermostat should be installed by an authorized dealer or service person.

To Install Thermostat:

• Disconnect unit from power supply.

• Open right side panel to gain access to rear of control panel.

• Take the thermostat wires and connect to the green screw terminal on the rear of

the control panel (see Figure 4).

When the room cools to below the thermostat setting the stove will automatically restart

and run at the last feed rate setting. When the room is warm enough the unit will shut

off. The exhaust fan will continue to run until the stove cools.

Figure 4

screw connection for

thermostat

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

No comments

Enviro 828 MH Specifications Page 12