Enviro 828 MH Specifications download pdf (Page 33)

TROUBLE SHOOTING

See figure 26, page 31, for component locations.

Condition 1: The unit will not light.

• Check that the unit is plugged in and that the wall outlet has power.

• Unplug the unit then check all electrical connections against the Wiring Diagram

in this manual.

• Check the fuse on the circuit board.

• If a thermostat is used, ensure it is calling for heat.

If your unit still does not light contact your local dealer for service.

Condition 2: The stove will not operate when hot.

• Check the hopper has fuel.

• Check that the combustion air inlet is not blocked. Insufficient air supply may

cause the fire to burn cold and may cause fuel build up, in the pot, and smother

the fire.

• Check that the exhaust fan is operating, if the fan is not operating properly it may

not generate enough vacuum in the firebox.

• Check the vacuum switch by shorting out the vacuum switch then turn the control

panel to "OFF" and back to “ON”. If the unit starts to operate change the vacuum

switch.

• Check the exhaust temperature switch (located on the exhaust blower) by shorting

out the exhaust temperature switch then turn the control panel to "OFF" and back

to “ON”. If the unit starts to operate change the exhaust temperature switch.

• Check the 250°F high limit switch. This switch is manually reset, check if it has

tripped, if so let cool and reset switch. Check for cause of overheating, if switch

trips again contact your local dealer for service.

Condition 3: Exhaust blower does not operate normally.

• Check all wiring connections.

• Apply 120 volts directly to the exhaust blower, if the blower does not run replace

the blower.

Condition 4: Convection blower does not operate normally.

• Check all wiring connections.

• Apply 120 volts directly to the convection blower, if the blower does not run

replace the blower.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39

No comments

Enviro 828 MH Specifications Page 33