Enviro 828 MH Specifications download pdf (Page 11)

OPERATING INSTRUCTIONS

Control Board Functions (continued)

Auger Trim: This is used to change the feed rate on the minimum heat level for various

quality of pellet fuel. This will help to keep the flames from extinguishing on the

minimum heat level setting. It is also used to lower heat output on the minimum heat

level setting.

Push and release the Auger Trim button until the heat level 1 and 5 lights appear. This

will slightly increase the feed rate on the minimum heat level setting to keep the burn pot

flames from going out.

Push and release the button until the heat level 1 and 4 lights appear, this will reduce the

pellet feed rate on the minimum heat level setting. Use this setting to reduce the heat

level output on low.

Push and release the button until just the heat level 1 setting light is on, this is the factory

setting and works for most types of fuel.

Figure 3 Control Panel

Open Door

If the door is opened, while the unit is operating, it

must be closed within 30 seconds or the unit will go

into vacuum error mode. If this happens, close the

door, turn the control panel switch to "OFF" then

back to the setting it was previously at.

Refueling

For maximum performance we recommend that you

do not let the hopper drop below 1/4 full. KEEP

LID CLOSED AT ALL TIMES EXCEPT WHEN

REFILLING. DO NOT OVERFILL HOPPER.

Safety Features

1. Your unit is equipped with a "high

temperature limit" thermo snap disc. This

snap disc serves to shutdown the auger in

the case of an over temperature situation

(such as convection fan failure). This disc

has a manual reset button that will have to

be reactivated once the unit has cooled

down.

2. If the combustion fan malfunctions a

vacuum switch will automatically shut down

the auger (see also Open Door section

above).

If either of these situations occur contact your dealer as a service call may be

required.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 38 39

No comments

Enviro 828 MH Specifications Page 11