Enviro EG40-071 User Manual

Browse online or download User Manual for Tools Enviro EG40-071. Enviro EG40-071 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED
PAPER.
B Y : S H E R W O O D I N D U S T R I E S L T D
OWNERS MANUAL
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
EG40-071
EG40 BV
This appliance may be installed in an after market permanently
located, manufactured (mobile) home, where not prohibited by
local codes.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other
gases, unless a certied kit is used.
WHAT TO DO IF YOU SMELL GAS
• Open windows/Extinguish any open ame.
• Do not try to light any appliance.
• Do not touch any electrical switch or use any phone in your
building.
Immediately call your gas supplier from a neighbour’s phone.
Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the re
department.
WARNING
If the information in this manual is not followed exactly, a re or explosion may
result causing property damage, personal injury or loss of life. Installation and
service must be performed by a qualied installer, service agency or the gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other Flammable vapours and liquids in the vicinity of
this or any other appliance.
Massachusetts installations (Warning): This product must be installed by a licensed
plumber or gas tter when installed within the Commonwealth of Massachusetts. Other
Massachusetts code requirements:-Flexible connector must not be longer than 36
inches, shut off valve must be a “T” handle gas cock, only direct vent sealed combustion
products are approved for bedroom/bathrooms, replace dampers must be removed or
welded in the open position prior to the installation of a replace insert or gas log.
Page view 0
1 2 3 4 5 6 ... 22 23

Summary of Contents

Page 1 - OWNER’S MANUAL

SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.B Y : S H E R W O O D I N D U S T R I E S

Page 2 - Safety Precautions

ADJUSTING THE VENTURIES:• There is a separate venturies for each burner, see Figure 9.• Remove one screw from the cover plate located below the ash

Page 3 - Table of Contents

11Initial InstallationFUEL CONVERSION:WARNING: This conversion kit shall be installed by a qualied service technician in accordance with

Page 4 - Codes And Approvals

Initial InstallationGAS LINE CONNECTION AND TESTING:WARNING: Only persons licensed to work with gas piping may make the necessary gas co

Page 5 - Specifications

13Secondary InstallationINSTALLATION OF LOG SET AND EMBERS:CAUTION: Use only the type of ember material supplied with this appliance. Due to the

Page 6

Secondary InstallationCAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED.4. Upon the rst light up, watch for ignition to ALL

Page 7

Operating InstructionsFOR YOUR SAFETY READ COMPLETELY BEFORE OPERATING.WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION M

Page 8

16Routine Maintenance and ServiceAnnually check to ensure that your Venting system is clear.Periodically check the pilot and burner. Check to see that

Page 9

Trouble ShootingProblem Possible Cause SolutionSpark will not light the pilot after repeatedly pressing the spark ignitorDefective piezo ignitor. • Ch

Page 10 - Initial Installation

Parts ListReference NumberPart Description Part Number1 120 °F (49 °C) Ceramic Temperature Sensor EC-0012 220 °F (104 °C) Ceramic Spill Switch EC-002

Page 11 - Table 3: Orice Information

19Parts ListReference NumberPart Description Part NumberBV Owner’s Manual EG40-07114 Pedestal EG40-08015 Side Panel EG40-086 16 BV Stove Top EG40-087

Page 12

FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” HEATER, PLEASE CAREFULLY READ THE FOLLOWING INFORMATION:• All ENVIRO gas-red appliances must be

Page 13 - Secondary Installation

Parts Diagram - ChassisEG 40 Body (Chassis)July 200420

Page 14

21Parts Diagram - Gas Tray & DoorEG40 Gas Tray & Door AssembliesJuly 200428921102435611712172726254

Page 15 - Operating Instructions

WarrantySherwood Industries Ltd. offers a Limited Lifetime Warranty on this gas product. This limited lifetime warranty covers the applian

Page 16 - Figure 19: Removing the Door

23Installation Data SheetThe following information must be recorded by the installer for warranty purposes and future reference.NAME OF OWNER:________

Page 17 - Trouble Shooting

Table of Contents3Safety Precautions...2Table of Contents...

Page 18 - Parts List

BV: This Vented appliance draws all of its combustion air from the dwelling and must be vented using listed B or L vent. May also be vented through a

Page 19

5WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxide (CO) poisoni

Page 20 - Parts Diagram - Chassis

Initial InstallationQUALIFIED INSTALLERS ONLYVENTING:This model must have a vent opening in the rear of the unit. Conrm this and also check that the

Page 21 - July 2004

Initial InstallationQUALIFIED INSTALLERS ONLYTERMINATION:7           

Page 22 - Warranty

8Initial InstallationQUALIFIED INSTALLERS ONLYSTRAIGHT VERTICAL INSTALLATION:Figure 5: Straight vertical installation. This basic venting congurat

Page 23 - (dd/mm/yyyy)

9Initial InstallationQUALIFIED INSTALLERS ONLYELECTRICAL REQUIREMENTS:The ENVIRO EG40 will operate without electrical power. This model has a millivol

Comments to this Manuals

No comments